Tundra 4WD V8-4.6L (1UR-FE) (2010)
(a) Temporarily install the speaker by attaching the claws of the speaker to the door panel.
(b) Install the speaker with the 3 screws.
NOTICE:
Do not touch the cone part of the speaker.
HINT
Install the screws in the order shown in the illustration.
(c) Connect the connector.
2. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH See: Body and Frame/Doors, Hood and Trunk/Doors/Rear Door/Service and
Repair/Rear Door (for Double Cab)/Reassembly
3. INSTALL COURTESY LIGHT ASSEMBLY See: Body and Frame/Doors, Hood and Trunk/Doors/Rear Door/Service and Repair/Rear Door
(for Double Cab)/Reassembly
4. INSTALL REAR DOOR ARMREST COVER LH
5. INSTALL REAR UPPER DOOR ARMREST BASE PANEL LH See: Body and Frame/Doors, Hood and Trunk/Doors/Rear Door/Service and
Repair/Rear Door (for Double Cab)/Reassembly
6. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG LH See: Body and Frame/Doors, Hood and Trunk/Doors/Rear Door/Service and
Repair/Rear Door (for Double Cab)/Reassembly
7. INSTALL REAR DOOR FRAME GARNISH LH See: Body and Frame/Doors, Hood and Trunk/Doors/Rear Door/Service and Repair/Rear
Door (for Double Cab)/Reassembly
8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
From 11/2009
AUDIO / VISUAL: REAR DOOR SPEAKER (for Double Cab): INSTALLATION
HINT
*
Use the same procedures for the LH side and RH side.
*
The procedures listed below are for the LH side.
1. INSTALL REAR NO. 1 SPEAKER ASSEMBLY
(a) Temporarily install the speaker by attaching the claws of the speaker to the door panel.
(b) Install the speaker with the 3 screws.
NOTICE:
Do not touch the cone part of the speaker.
HINT
Install the screws in the order shown in the illustration.
(c) Connect the connector.
2. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH See: Body and Frame/Doors, Hood and Trunk/Doors/Rear Door/Service and
Repair/Rear Door (for Double Cab)/Reassembly