Tundra 4WD V8-4.6L (1UR-FE) (2010)
Parts Information
Repair Procedure
1. Test-drive the vehicle and confirm the condition.
NOTE
Repeat remaining steps for both No.3 cab mounts.
2. Loosen the No.2 cab mount nuts (at front of cab) down to the last thread on the long bolt. This is necessary to allow the cab to be raised to remove
the No.3 mount.
The cab mounts in the front are only loosened to allow the technician to raise the cab to install the rear cab mounts. Not necessary to change.