Tundra 4WD V8-4.6L (1UR-FE) (2010)
(a) Disconnect the switch connector.
(b) Remove the 3 screws and switch.
Installation
SEAT: POWER SEAT SWITCH (w/o Seat Position Memory System): INSTALLATION
HINT
*
Use the same procedures for the LH side and RH side.
*
The procedures listed below are for the LH side.
1. INSTALL FRONT POWER SEAT SWITCH LH
(a) Install the switch with the 3 screws.
(b) Connect the switch connector.
2. INSTALL LEG SUPPORT ADJUSTMENT SWITCH (w/ Leg Support Adjustment Switch)
(a) Connect the switch connector.
(b) Install the switch with the 2 screws.
(c) Attach the 2 wire harness clamps.
3. INSTALL FRONT SEAT CUSHION SHIELD LH See: Service and Repair/Overhaul/Front Seat Assembly (for Power Seat)/Reassembly
4. INSTALL RECLINING POWER SEAT SWITCH KNOB LH See: Service and Repair/Overhaul/Front Seat Assembly (for Power
Seat)/Reassembly
5. INSTALL SLIDE AND VERTICAL POWER SEAT SWITCH KNOB LH See: Service and Repair/Overhaul/Front Seat Assembly (for Power
Seat)/Reassembly
6. INSTALL FRONT SEAT ASSEMBLY LH
(a) Install the front seat See: Service and Repair/Removal and Replacement/Front Seat Assembly (for Power Seat)/Installation.