Tundra 4WD V8-4.6L (1UR-FE) (2010)
/Page-2964010.png)
15. INSTALL TAIL GATE LOCK ASSEMBLY LH
(a) Using a T40 "TORX" wrench, install the tail gate lock with the 2 screws.
Torque : 13 Nm (133 kgf-cm, 10 ft-lbf)
(b) Connect one end of the tail gate lock link to the tail gate lock and another end to the tail gate handle.
16. INSTALL TAIL GATE LOCK ASSEMBLY RH
(a) Using a T40 "TORX" wrench, install the tail gate lock with the 2 screws.
Torque : 13 Nm (133 kgf-cm, 10 ft-lbf)
(b) Connect one end of the tail gate lock link to the tail gate lock and another end to the tail gate handle.
17. INSTALL TAIL GATE SERVICE HOLE COVER
(a) Using a T30 "TORX" wrench, install the service hole cover with the 8 screws.
18. INSTALL TAIL GATE PROTECTOR See: Tail Gate Protector/Installation
19. CHECK CONNECTION OF TELEVISION CAMERA ASSEMBLY (w/ Rear View Monitor System) See: Accessories and Optional
Equipment/Collision Avoidance and Parking Assist Systems/Rear Vision Camera/Service and Repair/Installation
