Tundra 4WD V8-4.6L (1UR-FE) (2010)
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
2. REMOVE REAR WHEEL
3. REMOVE REAR SPEED SENSOR LH
(a) Disconnect the speed sensor connector (labeled A).
(b) Remove the nut (labeled B) and speed sensor (labeled C).
4. REMOVE REAR SPEED SENSOR RH
(a) Disconnect the speed sensor connector (labeled A).
(b) Remove the nut (labeled B) and speed sensor (labeled C).
5. REMOVE SKID CONTROL SENSOR WIRE
(a) Disconnect the sensor connector (labeled A).
(b) Detach the 7 clips (labeled B).
(c) Remove the bolt (labeled C).
(d) Remove the nut (labeled D) and skid control sensor wire.
Installation
BRAKE CONTROL: REAR SPEED SENSOR: INSTALLATION