Tundra 4WD V8-4.6L (1UR-FE) (2010)
Intake Manifold: Service and Repair
Removal
1UR-FE INTAKE: INTAKE MANIFOLD: REMOVAL
1. DISCHARGE FUEL SYSTEM PRESSURE See: Powertrain Management/Fuel Delivery and Air Induction/Fuel Injector/Service and
Repair/Removal
2. REMOVE EGR VALVE ASSEMBLY
(a) Remove the EGR valve See: Powertrain Management/Emission Control Systems/Exhaust Gas Recirculation/EGR Valve/Service and
Repair/Removal.
3. REMOVE FRONT WIPER MOTOR AND LINK ASSEMBLY
(a) Remove the front wiper motor and link See: Wiper and Washer Systems/Wiper Motor/Service and Repair/Removal.
4. REMOVE COWL TOP OUTER PANEL SUB-ASSEMBLY
(a) Disconnect the washer hose and 2 wire harness clamps.
(b) Remove the 7 bolts and outer panel.
5. REMOVE VENTILATION HOSE ASSEMBLY
(a) Disconnect the ventilation hose from the ventilation pipe of the cylinder head cover LH and RH.
(b) Remove the bolt and ventilation hose.
6. REMOVE AIR TUBE SUB-ASSEMBLY LH See: Cooling System/Thermostat/Service and Repair/Removal
7. REMOVE INTAKE MANIFOLD
(a) Disconnect the No. 4 water by-pass hose.
(b) Disconnect the throttle body connector.
(c) Disconnect the No. 1 ventilation hose.
(d) Disconnect the purge VSV connector.