Tundra 4WD V8-4.6L (1UR-FE) (2010)
(j) Connect the purge VSV connector.
(k) Connect the purge line hose to the purge VSV.
(l) Connect the vacuum switching valve connector (for ACIS).
(m)Connect the No. 1 ventilation hose.
(n) Connect the No. 4 water by-pass hose.
(o) Connect the throttle body connector.
11. INSTALL VENTILATION HOSE ASSEMBLY
(a) Install the ventilation hose with the bolt.
Torque : 10 Nm (102 kgf-cm, 7 ft-lbf)
(b) Connect the ventilation hose to the ventilation pipe of the cylinder head cover LH and RH.
12. INSTALL AIR TUBE SUB-ASSEMBLY LH See: Cooling System/Thermostat/Service and Repair/Installation
13. INSTALL COWL TOP OUTER PANEL SUB-ASSEMBLY
(a) Install the outer panel with the 7 bolts.
Torque : 7.5 Nm (76 kgf-cm, 66 in-lbf)
(b) Connect the washer hose.
(c) Connect the 2 wire harness clamps.
14. INSTALL FRONT WIPER MOTOR AND LINK ASSEMBLY