Tundra 4WD V8-4.6L (1UR-FE) (2010)
NG -- REPAIR OR REPLACE CAN MAIN WIRE OR CONNECTOR (NO. 1 JUNCTION CONNECTOR - NO. 2 JUNCTION
CONNECTOR)
OK -- Continue to next step.
6. CONNECT CONNECTOR
(a) Reconnect the J94 No. 1 junction connector connector.
(b) Reconnect the J113 No. 2 junction connector connector.
NEXT -- Continue to next step.
7. CHECK FOR SHORT TO B+ IN CAN BUS WIRE (NO. 1 JUNCTION CONNECTOR - COMBINATION METER ECU)
(a) Disconnect the J84 No. 1 junction connector connector.
(b) Measure the resistance according to the value(s) in the table below.
Standard resistance:
NG -- CHECK FOR SHORT TO B+ IN CAN BUS WIRE (COMBINATION METER ECU)
OK -- Continue to next step.
8. CHECK FOR SHORT TO B+ IN CAN BUS WIRE (NO. 1 JUNCTION CONNECTOR - MAIN BODY ECU)
(a) Disconnect the J96 No. 1 junction connector connector.