Tundra 4WD V8-4.6L (1UR-FE) (2010)
/Page-1150055.png)
(a) Reconnect the J86 No. 1 junction connector connector.
NEXT -- Continue to next step.
4. CHECK FOR SHORT TO GND IN CAN BUS WIRE (NO. 2 JUNCTION CONNECTOR SIDE)
(a) Disconnect the J113 No. 2 junction connector connector.
(b) Measure the resistance according to the value(s) in the table below.
Standard resistance:
NG -- CHECK FOR SHORT TO GND IN CAN BUS WIRE (NO. 2 JUNCTION CONNECTOR - AIR CONDITIONING
AMPLIFIER)
OK -- Continue to next step.
5. CHECK FOR SHORT TO GND IN CAN BUS WIRE (NO. 1 JUNCTION CONNECTOR - NO. 2 JUNCTION CONNECTOR)
(a) Disconnect the J94 No. 1 junction connector connector.
(b) Measure the resistance according to the value(s) in the table below.
Standard resistance:
