Tundra 4WD V8-4.6L (1UR-FE) (2010)
/Page-1300001.png)
Air Injection Pump: Service and Repair
Removal
1UR-FE EMISSION CONTROL: AIR PUMP: REMOVAL
1. DISCONNECT FRONT FENDER LINER RH
(a) Remove the 8 clips, disconnect the fender liner.
2. DISCONNECT FRONT FENDER APRON SEAL RH
(a) Using a clip remover, remove the 2 clips and fold back the fender apron seal.
3. REMOVE NO. 2 AIR INJECTION SYSTEM HOSE
(a) Engine Room Side:
(1) Disconnect the 2 clamps.
(2) Disconnect the No. 2 air injection system hose.
(3) Using a clip remover, remove the clamp from the body panel.
(b) Front Fender RH Inside:
(1) Disconnect the clamp.
(2) Disconnect the No. 2 air injection system hose from the air pump.
4. REMOVE NO. 3 AIR INJECTION SYSTEM HOSE
(a) Engine Room Side:
