Tundra 4WD V8-4.6L (1UR-FE) (2010)
/Page-970001.png)
Fuel Pump Relay: Testing and Inspection
Fuel Pump Relay
1UR-FE ENGINE CONTROL SYSTEM: FUEL PUMP RELAY: ON-VEHICLE INSPECTION
1. REMOVE FUEL PUMP RELAY (F/PMP)
(a) Remove the fuel pump relay from the engine room relay block.
2. INSPECT FUEL PUMP RELAY
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
(b) If the result is not as specified, replace the fuel pump relay.
3. INSTALL FUEL PUMP RELAY
(a) Install the fuel pump relay to the engine room relay block.
