Tundra 4WD V8-4.6L (1UR-FE) (2010)
/Page-2400017.png)
(b) Disconnect the 2 clamps.
(c) Remove the 2 nuts and the front seat side airbag assembly.
CAUTION:
*
The nuts must not be reused.
*
Make sure that the seat frame assembly is not deformed. If it is, replace it with a new one.
Installation
SUPPLEMENTAL RESTRAINT SYSTEM: FRONT SEAT SIDE AIRBAG ASSEMBLY (except Fold Down Seat Type): INSTALLATION
CAUTION:
Wear protective gloves. Sharp areas on the seat frame and adjuster may injure your hands.
HINT
Use the same procedures for the LH side and RH side.
1. INSTALL FRONT SEAT SIDE AIRBAG ASSEMBLY
CAUTION:
*
The nuts must not be reused.
*
Make sure that the seat frame assembly is not deformed. If it is, replace it with a new one.
(a) Install the front seat side airbag assembly with 2 new nuts.
Torque : 5.5 Nm (56 kgf-cm, 49 in-lbf)
(b) Connect the 2 clamps.
(c) Connect the 3 wire harness clamps to under the seat.
