Tundra 4WD V8-4.6L (1UR-FE) (2010)
Air Bag Deactivation Switch: Service and Repair
Airbag Cut-OFF Switch
Components
SUPPLEMENTAL RESTRAINT SYSTEM: AIRBAG CUT-OFF SWITCH: COMPONENTS
Removal
SUPPLEMENTAL RESTRAINT SYSTEM: AIRBAG CUT-OFF SWITCH: REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt
pretensioner activation.
2. REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY
(a) Remove the lower No. 2 instrument panel airbag assembly See: Air Bag/Service and Repair/Removal and Replacement/Front Passenger Side
Knee Airbag Assembly/Removal.
3. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY RH See: Body and Frame/Interior Moulding /
Trim/Dashboard / Instrument Panel/Service and Repair/Removal and Replacement/Instrument Panel Safety Pad (for Column Shift Type)/Removal
4. REMOVE AIRBAG CUT-OFF SWITCH
(a) Detach the 2 claws to remove the switch.
Installation
SUPPLEMENTAL RESTRAINT SYSTEM: AIRBAG CUT-OFF SWITCH: INSTALLATION
1. INSTALL AIRBAG CUT-OFF SWITCH
(a) Attach the 2 claws to install the switch.
2. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard /
Instrument Panel/Service and Repair/Removal and Replacement/Instrument Panel Safety Pad (for Column Shift Type)/Installation
3. INSTALL LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY
(a) Install the lower No. 2 instrument panel airbag assembly See: Air Bag/Service and Repair/Removal and Replacement/Front Passenger Side
Knee Airbag Assembly/Installation.
4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL