Tundra 4WD V8-4.6L (1UR-FE) (2010)
Clockspring Assembly / Spiral Cable: Testing and Inspection
SUPPLEMENTAL RESTRAINT SYSTEM: SPIRAL CABLE: INSPECTION
1. REMOVE SPIRAL CABLE
(a) If there are any defects as mentioned below, replace the spiral cable with a new one:
Scratches, cracks, dents or chips on the connector or the spiral cable.
(b) Check the spiral cable.
(1) Set the spiral cable to the center position See: Service and Repair/Installation.
(2) After setting the spiral cable to the center position, rotate the spiral cable 2.5 times clockwise, and measure the resistance as shown. Then
rotate the spiral cable 5 times counterclockwise, measure the resistance according to the U4 (uecs) in the table below.
Standard resistance: