Tundra 4WD V8-4.6L (1UR-FE) (2010)
Torque : 9.0 Nm (92 kgf-cm, 80 in-lbf)
NOTICE:
*
If the side airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector,
replace it with a new one.
*
When installing the side airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched
between other parts.
(d) Check that there is no looseness in the installation parts of the side airbag sensor.
(e) Connect the connector.
8. INSTALL LOWER QUARTER TRIM PANEL ASSEMBLY LH (for Rear Side) See: Body and Frame/Interior Moulding /
Trim/Headliner/Service and Repair/Roof Headlining (For Double Cab)/Installation
9. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH (for Rear Side)
10. INSTALL REAR DOOR SCUFF PLATE LH (for Rear Side) See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Roof
Headlining (For Double Cab)/Installation
11. INSTALL REAR SEAT ASSEMBLY (for Rear Side)
(a) Install the rear seat assembly See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Rear Seat Assembly (for Double
Cab)/Installation.
12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
13. CHECK SRS WARNING LIGHT
(a) Check the SRS warning light See: Air Bag Systems/Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnosis System.
Components
SUPPLEMENTAL RESTRAINT SYSTEM: SIDE AIRBAG SENSOR (for Double Cab): COMPONENTS