Tundra 4WD V8-4.6L (1UR-FE) (2010)
/Page-2523001.png)
Seat Position Sensor: Testing and Inspection
SUPPLEMENTAL RESTRAINT SYSTEM: SEAT POSITION SENSOR: ON-VEHICLE INSPECTION
1. CHECK SEAT POSITION SENSOR (VEHICLE NOT INVOLVED IN COLLISION)
(a) Perform a diagnostic system check See: Air Bag Systems/Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnosis
System.
2. CHECK SEAT POSITION SENSOR (VEHICLE INVOLVED IN COLLISION)
(a) Perform a diagnostic system check See: Air Bag Systems/Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnosis
System.
(b) Even if the airbag was not deployed, check if there is any damage to the seat position sensor. If there are any defects as mentioned below,
replace the seat position sensor with a new one:
*
Cracks, dents or chips on the sensor housing.
*
Cracks or other damage to the connector.
CAUTION:
For removal and installation procedures of the seat position sensor, be sure to follow the correct procedure.
