Tundra 4WD V8-4.6L (1UR-FE) (2010)
Removal
SEAT: POWER SEAT SWITCH (w/o Seat Position Memory System): REMOVAL
HINT
*
Use the same procedures for the LH side and RH side.
*
The procedures listed below are for the LH side.
1. REMOVE FRONT SEAT ASSEMBLY LH
(a) Remove the front seat See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Front Seat Assembly (for Power
Seat)/Removal.
2. REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB LH See: Body and Frame/Seats/Service and Repair/Overhaul/Front Seat
Assembly (for Power Seat)/Disassembly
3. REMOVE RECLINING POWER SEAT SWITCH KNOB LH See: Body and Frame/Seats/Service and Repair/Overhaul/Front Seat Assembly
(for Power Seat)/Disassembly
4. REMOVE FRONT SEAT CUSHION SHIELD LH See: Body and Frame/Seats/Service and Repair/Overhaul/Front Seat Assembly (for Power
Seat)/Disassembly
5. REMOVE LEG SUPPORT ADJUSTMENT SWITCH (w/ Leg Support Adjustment Switch)
(a) Detach the 2 wire harness clamps and remove the 2 screws and switch.
(b) Disconnect the switch connector.
6. REMOVE FRONT POWER SEAT SWITCH LH