Tundra 4WD V8-4.6L (1UR-FE) (2010)
1. INSTALL SKID CONTROL SENSOR WIRE
(a) Install the sensor clamp with the nut (labeled A).
Torque : 13 Nm (127 kgf-cm, 9 ft-lbf)
NOTICE:
Make sure the clamp's rotation stopper touches the installation position.
(b) Install the sensor clamp with the bolt (labeled B).
Torque : 13 Nm (127 kgf-cm, 9 ft-lbf)
NOTICE:
When installing the clamp, do not twist the wire harness.
(c) Attach the 7 clips (labeled C).
NOTICE:
*
When installing the clamps, do not twist the wire harness.
*
When installing the clamps, securely insert them as shown in the illustration.
(d) Connect the sensor connector (labeled D).
NOTICE:
Securely connect the connector.
2. INSTALL REAR SPEED SENSOR LH
(a) Install the speed sensor (labeled A) with the nut (labeled B).
Torque : 11 Nm (107 kgf-cm, 8 ft-lbf)
(b) Connect the speed sensor connector (labeled C).
NOTICE:
Securely connect the connector.
3. INSTALL REAR SPEED SENSOR RH
(a) Install the speed sensor (labeled A) with the nut (labeled B).