Tundra 4WD V8-4.6L (1UR-FE) (2010)
(a) Remove the nut and bolt from the shock absorber lower side.
NOTICE:
To prevent the shock absorber with coil spring from falling, leave the bolt inserted.
(b) Remove the 4 nuts.
(c) Remove the bolt (lower side) and shock absorber with coil spring.
Installation
SUSPENSION: FRONT SHOCK ABSORBER: INSTALLATION
HINT
*
Use the same procedures for the RH side and LH side.
*
The procedures listed below are for the LH side.
*
A bolt without a torque specification is shown in the standard bolt chart See: Specifications/Mechanical Specifications/Standard
Bolt - Specified Torque For Standard Bolts
1. TEMPORARILY INSTALL FRONT SHOCK ABSORBER WITH COIL SPRING
(a) Temporarily install the upper side of the shock absorber to the chassis frame with the 4 nuts.
(b) Temporarily install the lower side of the shock absorber to the lower suspension arm with the bolt, washer and nut.
2. STABILIZE SUSPENSION
(a) Lower the vehicle.