Tundra 4WD V8-4.6L (1UR-FE) (2010)
Torque : 14 Nm (143 kgf-cm, 10 ft-lbf)
NOTICE:
When connecting the cable to the transmission control shaft lever, make sure the L bracket of the cable faces the inside of the vehicle.
(g) Connect the transmission control cable support with the nut.
Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)
2. ADJUST SHIFT LEVER POSITION See: Shifter A/T/Adjustments/SHIFT LEVER ASSEMBLY (for Floor Shift Type)
3. INSPECT SHIFT LEVER POSITION See: Shifter A/T/Adjustments/SHIFT LEVER ASSEMBLY (for Floor Shift Type)
4. INSTALL FRONT CONSOLE BOX See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Removal
and Replacement/Instrument Panel Safety Pad (for Floor Shift Type)/Installation
5. INSTALL REAR CONSOLE BOX ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Removal and Replacement/Instrument Panel Safety Pad (for Floor Shift Type)/Installation
6. INSTALL CONSOLE BOX CARPET
7. INSTALL REAR CONSOLE END PANEL SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument
Panel/Service and Repair/Removal and Replacement/Instrument Panel Safety Pad (for Floor Shift Type)/Installation
8. INSTALL REAR UPPER CONSOLE PANEL SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument
Panel/Service and Repair/Removal and Replacement/Instrument Panel Safety Pad (for Floor Shift Type)/Installation
9. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service
and Repair/Removal and Replacement/Instrument Panel Safety Pad (for Floor Shift Type)/Installation
10. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH See: Body and Frame/Interior Moulding / Trim/Dashboard
/ Instrument Panel/Service and Repair/Removal and Replacement/Instrument Panel Safety Pad (for Floor Shift Type)/Installation
11. INSTALL COWL SIDE TRIM BOARD LH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Roof Headlining (For
Regular Cab)/Installation
12. INSTALL FRONT DOOR SCUFF PLATE LH (for Double Cab, CrewMax) See: Body and Frame/Interior Moulding / Trim/Headliner/Service
and Repair/Roof Headlining (For Double Cab)/Installation
13. INSTALL FRONT DOOR SCUFF PLATE LH (for Regular Cab) See: Body and Frame/Interior Moulding / Trim/Headliner/Service and
Repair/Roof Headlining (For Regular Cab)/Installation