Tundra 4WD V8-4.6L (1UR-FE) (2010)
(c) Install the valve body with the 19 bolts.
Torque : 11 Nm (112 kgf-cm, 8 ft-lbf)
HINT
Each bolt length is indicated below.
36 mm (1.42 in.) for bolt A
25 mm (0.984 in.) for bolt B
45 mm (1.77 in.) for bolt C
50 mm (1.97 in.) for bolt D
(d) Install the detent spring and detent spring cover with the bolt.
Torque : 10 Nm (102 kgf-cm, 7 ft-lbf)
2. CONNECT TRANSMISSION WIRE See: Wiring Harness/Service and Repair/Installation
3. INSTALL VALVE BODY OIL STRAINER ASSEMBLY See: Wiring Harness/Service and Repair/Installation
4. INSTALL AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY See: Wiring Harness/Service and Repair/Installation
5. ADD AUTOMATIC TRANSMISSION FLUID
(a) Add automatic transmission fluid See: Service and Repair/Procedures.