Tundra 4WD V8-4.6L (1UR-FE) (2010)
/Page-1607030.png)
28. REMOVE FRONT DIFFERENTIAL SIDE GEAR SHAFT RH BEARING
(a) Using a snap ring expander, remove the snap ring.
(b) Using SST, a brass bar and press, press out the bearing.
SST : 09950-00020
SST : 09950-70010
09951-07100
SST : 09950-60010
09951-00450
NOTICE:
Do not damage the bearing.
29. INSPECT DIFFERENTIAL CLUTCH SLEEVE AND DIFFERENTIAL CLUTCH HUB
(a) Check for wear and damage to the clutch hub and clutch sleeve.
(b) If necessary, replace them.
(c) Check that the clutch sleeve slides smoothly on the clutch hub.
