Tundra 4WD V8-4.6L (1UR-FE) (2010)
/Page-1607031.png)
30. INSPECT DIFFERENTIAL CLUTCH SLEEVE AND DIFFERENTIAL SIDE GEAR INTER SHAFT
(a) Check for wear and damage to the clutch hub and side gear inter shaft.
(b) Check that the clutch sleeve slides smoothly on the side gear inter shaft.
31. INSPECT DIFFERENTIAL CLUTCH SLEEVE AND CLUTCH SLEEVE FORK CLEARANCE
(a) Using a feeler gauge, measure the clearance between the sleeve fork and clutch sleeve.
Maximum clearance:
0.35 mm (0.0138 in.)
(b) If the clearance exceeds the maximum, replace the fork or clutch sleeve.
Reassembly
DIFFERENTIAL: FRONT DIFFERENTIAL CARRIER ASSEMBLY (for 4WD): REASSEMBLY
1. INSTALL STRAIGHT PIN
(a) Using a plastic-faced hammer, tap in the straight pins until their protrusion amounts are at the specified values shown in the illustration below.
