Tundra 4WD V8-4.6L (1UR-FE) (2010)
/Page-1607040.png)
Standard backlash:
0.17 to 0.27 mm (0.00670 to 0.01064 in.)
(b) If the backlash is not within the specification, adjust it by either increasing or decreasing the thickness of the washers on both sides by an equal
amount.
HINT
*
There should be no clearance between the plate washer and differential case.
*
Make sure that there is ring gear backlash.
Washer thickness:
21. INSPECT TOTAL PRELOAD
(a) Using a torque wrench, measure the preload with the teeth of the drive pinion and ring gear in contact.
