Tundra 4WD V8-4.6L (1UR-FE) (2010)
(l) If the boots are stretched or contracted, correct them.
(m)Install the inboard joint boot clamps in the same manner as the outboard side.
HINT
Adjust the clearance of the inboard joint boot clamps.
Standard clearance:
6. INSPECT FRONT DRIVE SHAFT ASSEMBLY See: Testing and Inspection/Component Tests and General Diagnostics/Front Drive Shaft
Assembly
Disassembly
AXLE: REAR AXLE SHAFT: DISASSEMBLY
1. REMOVE REAR AXLE SHAFT SNAP RING
(a) Using a snap ring expander, remove the snap ring.
2. REMOVE REAR AXLE SHAFT
(a) Using SST and a press, press out the rear axle shaft.
SST : 09521-25011
SST : 09521-60010
(b) Remove the rear axle bearing inner retainer from the axle hub.
(c) Remove the rear axle shaft washer from the axle hub.