Tundra 4WD V8-4.6L (1UR-FE) (2010)
Control Module: Service and Repair
Removal
JF1A TRANSFER: 4WD CONTROL ECU: REMOVAL
1. REMOVE FRONT DOOR SCUFF PLATE RH (for Regular Cab)
(a) Remove the front door scuff plate RH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Roof Headlining (For
Regular Cab)/Removal.
HINT
Use the same procedures described for the LH side.
2. REMOVE FRONT DOOR SCUFF PLATE RH (for Double Cab, for CrewMax)
(a) Remove the front door scuff plate RH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Roof Headlining (For
Double Cab)/Removal.
HINT
Use the same procedures described for the LH side.
3. REMOVE COWL SIDE TRIM BOARD RH
(a) Remove the cowl side trim board RH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Roof Headlining (For
Regular Cab)/Removal.
HINT
Use the same procedures described for the LH side.
4. REMOVE INSTRUMENT SIDE PANEL RH See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Removal and Replacement/Instrument Panel Safety Pad (for Column Shift Type)/Removal
5. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY RH See: Body and Frame/Interior Moulding /
Trim/Dashboard / Instrument Panel/Service and Repair/Removal and Replacement/Instrument Panel Safety Pad (for Column Shift Type)/Removal
6. REMOVE 4WD CONTROL ECU
(a) Disconnect the 2 ECU connectors.
(b) Remove the bolt and ECU.