Tundra 4WD V8-4.6L (1UR-FE) (2010)
NOTICE:
*
Pressing the drill too firmly will cause the rivet to turn and result in the rivet not being drilled through.
*
Do not pry the rivets with the drill, because this may cause damage to the installation holes of the rivets or the drill bit.
*
Be careful of the drilled rivets as they may become hot.
(d) Using a vacuum cleaner, remove the rivet fragments and shavings from the drilled areas.
(e) Remove the 3 clips and back window outside moulding.
27. REMOVE UPPER CAB REAR PILLAR PLATE LH
(a) Remove the 4 bolts and upper plate.
28. REMOVE UPPER CAB REAR PILLAR PLATE RH
HINT
Use the same procedures described for the LH side.
Installation
WINDSHIELD / WINDOWGLASS: BACK WINDOW GLASS (for CrewMax): INSTALLATION
HINT
A bolt without a torque specification is shown in the standard bolt chart See: Specifications/Mechanical Specifications/Standard Bolt -
Specified Torque For Standard Bolts
1. INSTALL UPPER CAB REAR PILLAR PLATE LH
(a) Align the positioning hole with the claw, and install the upper plate with the 4 bolts as shown in the illustration.
2. INSTALL UPPER CAB REAR PILLAR PLATE RH
HINT
Use the same procedures described for the LH side.
3. INSTALL BACK WINDOW OUTSIDE MOULDING