Tundra 4WD V8-4.6L (1UR-FE) (2010)
/Page-3321014.png)
(f) Using suction cups, remove the back window glass.
NOTICE:
If the stopper is damaged, the back window glass assembly must be replaced. Be careful when performing the procedure.
32. REMOVE UPPER OUTSIDE BACK WINDOW MOULDING (for Slide Type, for Power Slide Type)
HINT
Perform the following procedure if replacing the back window moulding.
(a) Using a moulding remover, detach the 3 clips and remove the back window moulding.
33. REMOVE LOWER OUTSIDE BACK WINDOW MOULDING (for Slide Type, for Power Slide Type)
HINT
Perform the following procedure if replacing the back window moulding.
(a) Using a moulding remover, detach the 3 clips and remove the back window moulding.
34. CLEAN BACK WINDOW ASSEMBLY
(a) Using a scraper, remove the damaged spacers and adhesive sticking to the glass.
(b) Clean the outer edge of the back window with a non-residue solvent.
NOTICE:
