Tundra 4WD V8-4.6L (1UR-FE) (2010)
/Page-3321019.png)
(3) Wipe off any tape adhesive residue with cleaner.
(b) If reusing the moulding:
Clean the moulding.
(1) Using a heat light, heat the moulding.
(2) Remove the double-sided tape from the moulding.
(3) Wipe off any tape adhesive residue with cleaner.
(4) Apply new double-sided tape to the moulding, as shown in the illustration.
(c) Install the moulding.
(1) Using a heat light, heat the back window and moulding.
(2) Remove the peeling paper.
(3) Attach the 3 clips to install the moulding.
6. INSTALL LOWER OUTSIDE BACK WINDOW MOULDING (for Slide Type, for Power Slide Type)
(a) Clean the back window surface.
(1) Using a heat light, heat the back window surface.
(2) Remove the double-sided tape from the back window.
(3) Wipe off any tape adhesive residue with cleaner.
(b) If reusing the moulding:
Clean the moulding.
(1) Using a heat light, heat the moulding.
(2) Remove the double-sided tape from the moulding.
(3) Wipe off any tape adhesive residue with cleaner.
(4) Apply new double-sided tape to the moulding, as shown in the illustration.
(c) Install the moulding.
(1) Using a heat light, heat the back window and moulding.
(2) Remove the peeling paper.
(3) Attach the 3 clips to install the moulding.
7. INSTALL REAR ROOF DRIP SIDE FINISH MOULDING LH
8. INSTALL REAR ROOF DRIP SIDE FINISH MOULDING RH
