Tundra 4WD V8-4.6L (1UR-FE) (2010)
/Page-3330003.png)
(a) Using a brush, apply Primer M to the exposed part of the vehicle body.
NOTICE:
*
Allow the primer to dry for 3 minutes or more.
*
Do not apply primer to the adhesive.
*
Throw away any leftover primer.
*
Do not apply too much primer.
(b) Using a brush or sponge, apply Primer G to the contact surface of the glass.
HINT
If the primer is applied to an area that is not specified, apply non-residue solvent to a clean cloth and wipe off the excess primer.
NOTICE:
*
Allow the primer to dry for 3 minutes or more.
*
Throw away any leftover primer.
*
Do not apply too much primer.
(c) Apply adhesive to the glass.
Adhesive:
Toyota Genuine Windshield Glass Adhesive or equivalent
(1) Cut off the tip of the cartridge nozzle as shown in the illustration.
HINT
After cutting off the tip, use all adhesive within the time written in the table below.
