Tundra 4WD V8-4.7L (2UZ-FE) (2003)
b. Insert the special tool into terminal 20 of the connector.
c. Move the locking clip to the unlock position and hold it there.
CAUTION:
^
Do not apply excessive force to the terminal.
^
Do not pry on the terminal with the special tool, as it may damage the terminal.
d. Carefully pull out the terminal from the connector by pulling the lead (color: R-B) toward the rear of the connector.
CAUTION:
Do not apply excessive force. If it is difficult to pull out the terminal, repeat steps (a) through (d).
6.
Install New Connector.