Tundra 4WD V8-4.7L (2UZ-FE) (2003)
A.
Using a screwdriver, raise the terminal retaining clip to the unlock position.
B.
Install the wire removed in step (5B) to the connector housing.
C.
Push down the retainer to the lock position.
D.
Reconnect the "harness to harness" connector IA4 that was separated in step 5A.
7.
Install Sub-Wire Harness.
A.
Connect the connector as shown in the illustration.
B.
Wrap the connector with urethane sheet.