Tundra 4WD V8-4.7L (2UZ-FE) (2003)
HINT: Tape the screwdriver tip before use.
d. Remove the bolt and front seat outer belt floor anchor.
e. Remove the quarter trim.
1. Using a screwdriver, remove the quarter trim belt hole cover.
HINT: Tape the screwdriver tip before use.
2. Using a screwdriver, remove the cap.
HINT: Tape the screwdriver tip before use.
3. Remove the bolt and front seat outer belt shoulder anchor.
4. Using a screwdriver, remove the quarter trim.
HINT: Tape the screwdriver tip before use.
f.
Remove the retractor of front seat outer belt.
CAUTION: Never disassemble the front seat outer belt.
NOTE: When removing the retractor of front seat outer belt, take care not to pull the seat belt pretensioner wire harness.