Tundra 4WD V8-4.7L (2UZ-FE) (2003)
d. Using SST, a press and steel plate, install a new No. 2 bushing.
SST 09631-12090, 09950-60020 (09951-00680)
HINT: Before installing the bushing, set it in the correct direction, as shown in the illustration.
2. REPLACE NO. 1 AND NO. 2 SPRING BUMPERS ON-VEHICLE
a. Remove the front wheel.
b. Using SST, replace the No. 1 spring bumper.
SST 09922-10010
HINT: At the time of installation, use a torque wrench with a fulcrum length of 345 mm (13.58 inch).
Torque: 23 Nm (235 kgf-cm, 17 ft. lbs.)
c. Replace No. 2 spring bumper.
1) Remove the stabilizer bar.
2) Using SST, replace the No. 2 spring bumper.
SST 09922-10010
HINT: At the time of installation, use a torque wrench with a fulcrum length of 345 mm (13.58 inch).
Torque: 23 Nm (235 kgf-cm, 17 ft. lbs.)
3) Install the stabilizer bar.
d. Install the front wheel.
Torque: 110 Nm (1,150 kgf-cm, 83 ft. lbs.)
INSTALLATION
1. INSTALL LOWER SUSPENSION ARM TO CHASSIS FRAME
Install the lower suspension arm with the 2 cams, bolts and cam plates while slightly shifting the power steering gear rearward.
Torque: 130 Nm (1,325 kgf-cm, 96 ft. lbs.)
NOTICE: Do not damage the power steering gear tubes.
HINT: After stabilizing the suspension, align the matchmarks on the front and rear cam plates and chassis frame, and torque the bolts.