Tundra 4WD V8-5.7L (3UR-FBE) Flex Fuel (2011)
_flex_fuel/Page-96002.png)
^
Pushing the "N" switch turns the compass
^
display ON or OFF.
3. Push the "N" switch to select the number of the zone where the vehicle is located. See the map in Figure 3 for zone reference.
4. Once the correct zone is selected start the engine and push and hold the "N" switch until "CAL" appears on the display (approximately 6 seconds).
5. Drive the vehicle slowly at 5mph (8 km/h) or less in a circle until the direction is displayed. If there is NOT enough space to drive in a circle, turn the
vehicle around as shown, doing two three-point turns in succession.
Once the direction is displayed, the calibration is complete.
^
Do NOT perform calibration of the compass in a place where the Earth's magnetic field is subject to interference (underground parking, under a
steel tower, between buildings, roof parking, near a railroad crossing, near a large vehicle, etc.)
^
During calibration, do NOT operate electric systems (moon roof, power windows, etc.) as they may interfere with the calibration.
