Tundra 4WD V8-5.7L (3UR-FE) (2007)
NOTE: Some systems need to be initialized after the cable is reconnected.
NOTE: After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and
settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery
terminal.
2. REMOVE LOWER NO.2 STEERING WHEEL COVER
3. REMOVE LOWER NO.3 STEERING WHEEL COVER
4. REMOVE STEERING PAD (w/o Steering Pad Switch)
5. REMOVE STEERING PAD (w/ Steering Pad Switch)
6. REMOVE CRUISE CONTROL MAIN SWITCH
a. Disconnect the connector.
b. Remove the 2 screws.
c. Remove the switch, as shown in the illustration.
INSTALLATION
1. INSTALL CRUISE CONTROL MAIN SWITCH
a. Install the switch, as shown in the illustration.