Tundra 4WD V8-5.7L (3UR-FE) (2007)
10. DISCONNECT WATER BY-PASS PIPE
(a)
Disconnect the No. 6 water by-pass hose.
(b) Remove the 3 bolts.
(c)
Disconnect the water by-pass pipe with water hose.
11. REMOVE WATER INLET HOUSING
(a)
Disconnect the No. 2 and No. 3 air hoses.
(b) Disconnect the air pump's connector.
(c)
Disconnect the air pump connector clamp's holder.
(d) Using a clip remover, detach the wire harness clamp.
(e)
Disconnect the No. 5 water by-pass hose.
(f)
Remove the air tube bracket's bolt.
(g) Remove the 3 bolts, water inlet housing and No. 3 water by-pass hose.
(h) Remove the gasket from the water pump.