Tundra 4WD V8-5.7L (3UR-FE) (2007)
Oil Filter: Technical Service Bulletins
Engine - Oil Filter Cap Assembly Precaution
T-SB-01 04-09
April 10, 2009
Oil Filter Cap Assembly Precautions
Service Category
Engine/Hybrid System
Section
Lubrication
Market
USA
Applicability
TSB SUPERSESSION NOTICE
The information contained in this TSB supersedes TSB No. T-SB-0332-08.
^
Applicability has been updated to include 2009 - 2010 model year Highlander, 2010 model year Camry, Corolla, Matrix, Sequoia, Tundra, and
2009 model year Venza vehicles.
^
The SST table has been updated with an illustration.
^
The Notice in the Repair Procedure has been updated with a Figure and torque specification ranges to clarify SST usage.
TSB No. T-SB-0332-08 is Obsolete and any printed versions should be discarded. Be sure to review the entire content of this service bulletin before
proceeding.
Introduction
To prevent damage to the oil filter cap assembly this procedure must be closely followed during oil filter replacement to avoid immediate and future oil
filter serviceability concerns.
The following engines are equipped with a plastic oil filter cap assembly:
^
1UR-FE (Tundra Sequoia)
^
3UR-FE (Tundra Sequoia Land Cruiser)
^
2ZR-FE (Corolla Matrix)