Tundra 4WD V8-5.7L (3UR-FE) (2007)
(d) Set the wheel disc to a mounting machine and install the lower tire bead. Position the main body of the tire pressure warning valve and
transmitter in the shaded area as shown in the illustration.
NOTICE:
^
If the tire pressure warning valve and transmitter is positioned outside this area, the tire bead will interfere with the tire pressure warning
valve and transmitter, and may cause damage to it.
^
If the use of lubricant is required when installing the bead, do not apply the lubricant directly to the tire pressure warning valve and
transmitter.
(e)
Install the upper bead.
NOTICE: Make sure that the tire bead and tool do not interfere with the main body of the tire pressure warning valve and transmitter and
that the tire pressure warning valve and transmitter is not clamped by the bead.
(f)
Inflate the tire. Retighten the nut to the specified torque and then check for air leaks with soapy water.
Torque: 4.0 Nm (41 kgf-cm, 35 inch lbs.)
NOTICE: No further tightening is required once the nut is tightened with the specified torque.
2. INSTALL WHEEL
Torque:
for Aluminum Wheel 131 Nm (1336 kgf-cm, 97 ft. lbs.)
for Steel Wheel 209 Nm (2131 kgf-cm, 154 ft. lbs.)
3. INSPECT TIRE
(a)
Inspect the tire.
4. REGISTRATION OF TRANSMITTER ID
(a)
Register the transmitter ID.
5. PERFORM INITIALIZATION
(a)
Perform initialization.
NOTICE: Be sure to inflate all tires to the proper inflation pressure before initialization.
6. CHECK TIRE PRESSURE AFTER REPAIRS