Tundra 4WD V8-5.7L (3UR-FE) (2007)
Tire Pressure Warning Reset Switch: Service and Repair
TIRE PRESSURE WARNING RESET SWITCH
REMOVAL
1. REMOVE INSTRUMENT SIDE PANEL LH
2. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH
3. REMOVE TIRE PRESSURE WARNING RESET SWITCH
(a)
Disconnect the switch connector.
(b) Detach the 2 claws and remove the reset switch.
INSPECTION
Component without harness connected: (Tire Pressure Warning Reset Switch)
1. CHECK TIRE PRESSURE WARNING RESET SWITCH
(a)
Measure the resistance of the switch.
Standard resistance
If the result is not as specified, replace the switch.
INSTALLATION