Tundra 4WD V8-5.7L (3UR-FE) (2007)
/Page-802003.png)
1. INSTALL GASKET
a. Clean the ECM seal's surface with non-residue solvent.
b. Attach a new gasket to the ECM.
2. INSTALL ECM
a. Install the ECM with the 4 bolts.
Torque: 8.0 N.m (82 kgf.cm, 71 in.lbf)
NOTE:
-
Make sure the gasket is not folded or caught on any area on the surrounding part.
-
Make sure there is no foreign matter caught between the gasket and surrounding part.
-
Do not damage the gasket.
b. Connect the 2 ECM connectors and push each lock lever down to lock the ECM connectors.
NOTE:
-
Make sure that the lock lever is raised 90 degrees before connecting the ECM connectors. Failure to do this may cause the lock lever and
terminals to break.
-
Do not twist the wire harness when connecting the ECM connectors.
3. INSTALL CONNECTOR HOLDER BLOCK
a. Install the connector holder block with the 3 bolts.
