Tundra 4WD V8-5.7L (3UR-FE) (2007)
/Page-811030.png)
Step 12(Continued)-14
INSPECTION PROCEDURE
HINT:
-
Perform the following inspection for the ECUs (sensors) which are not displayed on the intelligent tester or Techstream. If a malfunction cannot be
identified, perform the following inspections for the ECUs (sensors) connected to the CAN communication system.
-
Do not remove the combination meter and ECM, as they are the end parts of the circuit. If removed, CAN communication will not be possible.
-
The open circuit confirmation of the combination meter, ECM and main wire is performed in the CHECK CAN BUS LINE procedure of "HOW
