Tundra 4WD V8-5.7L (3UR-FE) (2007)
1. ADJUST PARK/NEUTRAL POSITION SWITCH ASSEMBLY
(a)
Loosen the bolt of the park/neutral position switch and move the shift lever to the N position.
(b) Align the groove with the neutral basic line.
(c)
Hold the switch in the position described above and tighten the bolt.
Torque: 13 Nm (13 kgf-cm, 10 ft. lbs.)
(d) After the adjustment, perform the on-vehicle inspection.
INSTALLATION
1. INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY
(a)
Install the switch to the manual valve shaft.
(b) Temporarily install the bolt.
(c)
Install a new lock washer with the nut.
Torque: 6.9 Nm (70 kgf-cm, 61 inch lbs.)
(d) Temporarily install the control shaft lever RH.