Tundra 4WD V8-5.7L (3UR-FE) (2007)
/Page-927002.png)
a. Disconnect the fuel tube clamp from the bracket.
8. REMOVE NO. 1 ENGINE COVER
9. REMOVE FRONT WATER BY-PASS JOINT
a. Disconnect the engine coolant temperature sensor connector.
b. Remove the 4 nuts, front water by-pass joint and 2 gaskets.
10. REMOVE AIR TUBE
a. Disconnect the No. 2 and No. 3 hoses.
b. Disconnect the air pump's connector.
c. Disconnect the air pump connector clamp's holder.
d. Using a clip remover, detach the wire harness claw.
