Tundra 4WD V8-5.7L (3UR-FE) (2007)
/Page-932006.png)
d. Connect the clamp to the No. 3 hose and wire harness shown in the illustration labeled D.
Then insert the clamp's clip into the body hole.
HINT: Align the pain mark of the No. 3 hose and paint mark of the wire harness with the edge of the clamp.
6. INSTALL NO. 2 AIR INJECTION SYSTEM HOSE
a. Connect the No. 2 hose so that its paint mark aligns with the air pump's rib as shown in the illustration labeled E.
b. Connect the No. 2 hose to the air tube shown in the illustration labeled F.
HINT:
-
Make sure the paint mark of the No. 2 hose is facing upward.
-
Make sure the direction of the hose clamp is as shown in the illustration.
c. Connect the white colored clamp to the No. 2 hose and wire harness shown in the illustration labeled G.
HINT:
-
Make sure the paint mark of the No. 2 hose is facing upward.
-
Make sure the direction of the hose clamp is as shown in the illustration.
d. Connect the black colored clamp to the No. 2 hose and wire harness shown in the illustration labeled H. Then insert the clamp's clip into the
body hole.
7. CONNECT FRONT FENDER APRON SEAL RH
