Tundra 4WD V8-5.7L (3UR-FE) (2007)
9.
Install the No. 1 engine cover.
NOTE:
Make sure that the No. 1 engine cover is level with the top surface of the intake port of the cylinder head for 1 and 2.
HINT:
^
Align the No. 1 engine cover cutouts with the air tube.
^
Align the No. 1 engine cover with the air switching valve surface and cylinder head wall.
10.
Install the No. 2 engine cover.
Make sure that the No. 2 engine cover is level with the top surface of the intake port of the cylinder head.
^
Align the No. 2 engine cover cutout with the air tube.
^
Align the No. 2 engine cover with the front water by-pass joint and cylinder head wall.
11.
Install the intake manifold assembly.
Refer to the Technical Information System (TIS), 2007 model year Tundra Repair Manual, Engine/Hybrid System - Intake/Exhaust - "3UR-FE
Intake: Intake Manifold: Installation".
12.
Clear all stored DTCs.
13.
Test drive the vehicle to confirm normal operation and that DTC P032D is NOT present.