Tundra 4WD V8-5.7L (3UR-FE) (2007)
b. for Regular Cab:
Remove the front door scuff plate.
2. REMOVE COWL SIDE TRIM BOARD LH
a. for Double Cab:
Remove the cowl side trim board.
b. for Regular Cab:
Remove the cowl side trim board.
3. REMOVE INSTRUMENT SIDE PANEL LH
4. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH
5. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY
6. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY
7. REMOVE REAR UPPER CONSOLE PANEL SUB-ASSEMBLY
8. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY
9. REMOVE CENTER LOWER INSTRUMENT PANEL FINISH PANEL
10. REMOVE INTEGRATION CONTROL AND PANEL ASSEMBLY
a. Detach the 4 clips.
b. Disconnect the integration control and panel connectors and remove the panel.
11. REMOVE SEAT HEATER SWITCH LH
a. Detach the 2 claws and remove the seat heater switch.
12. REMOVE SEAT HEATER SWITCH RH
a. Detach the 2 claws and remove the seat heater switch.
INSTALLATION