Tundra 4WD V8-5.7L (3UR-FE) (2007)
Crankshaft Position Sensor: Service and Repair
REMOVAL
1. REMOVE CRANKSHAFT POSITION SENSOR PROTECTOR
a. Remove the 2 bolts and sensor protector.
2. REMOVE CRANKSHAFT POSITION SENSOR
a. Disconnect the sensor connector.
b. Remove the bolt and sensor.
INSTALLATION
1. INSTALL CRANKSHAFT POSITION SENSOR
a. Install the sensor with the bolt.
Torque: 10 N.m (102 kgf.cm, 7 ft.lbf)
b. Connect the sensor connector.