toyota Workshop Repair Guides

Toyota Workshop Service and Repair Manuals

Electrical - MIL ON/DTC P0705 Set After Trailer Towing|Page 7635 > < Electrical - MIL ON/DTC P0705 Set After Trailer Towing|Page 7633
Page 3
background image

3.

Check the 10 amp "back-up lamp" fuse for an open circuit.

NOTE

^

The back-up lamp fuse is listed as "BK/UP LP" on the fuse block assembly.

^

The back-up lamp fuse is located in the fuse block on the left side of the passenger compartment below the dashboard near the left front
kick panel.

Does the back-up lamp fuse have an open circuit?

^

YES - Continue with this TSB. Go to step 4.

^

NO - This TSB does NOT apply.

Refer to TIS, 2007 model year Tundra Repair Manual for diagnosis of this condition.

Drivetrain - Automatic Transmission/Transaxle - AB60E / AB60F / A750E (2UZ-FE) / A750F Automatic Transmission: Automatic
Transmission System: P0705: Transmission Range Sensor Circuit Malfunction (PRNDL Input)"

4.

Replace the back-up lamp fuse.

5.

Using TIS Techstream clear all DTCs and confirm a DTC does NOT return when the shifter is moved through all gear positions. If a DTC returns
refer to the Repair Manual for further diagnosis.

^

If the back-up lamp fuse has another open circuit - inspect the circuit for the root cause of the high current condition.

Electrical - MIL ON/DTC P0705 Set After Trailer Towing|Page 7635 > < Electrical - MIL ON/DTC P0705 Set After Trailer Towing|Page 7633