toyota Workshop Repair Guides

Toyota Workshop Service and Repair Manuals

Electrical - No Start/MIL ON/DTC B2799|Page 7911 > < Diagram Information and Instructions|Page 7902
Page 1
background image

Wiring Harness: Customer Interest
Electrical - No Start/MIL ON/DTC B2799

T-SB-0220-08

Rev1

August 11, 2008

M.I.L. "ON" DTC B2799 "No Start" Due to Harness Water Intrusion

Service Category
Vehicle Interior

Section
Theft Deterrent/Keyless Entry

Market
USA

Applicability 

TSB REVISION NOTICE

-

November 12, 2008 Rev1:
-

The Production Change Information section has been updated with new VIN information.

Any previous printed versions of this service bulletin should be discarded.

Introduction

Some 2007 - 2008 model year Tundra vehicles may exhibit a "no start" condition with Diagnostic Trouble Code (DTC) B2799 caused by water intrusion
into the engine room wire harness. Follow the procedures in this bulletin to inspect and replace the engine room wire harness as necessary to address
customer concerns.

NOTE:  

This TSB ONLY applies to vehicles exhibiting a "no start" condition with DTC B2799 and water or corrosion in connectors.

Electrical - No Start/MIL ON/DTC B2799|Page 7911 > < Diagram Information and Instructions|Page 7902